how to change the ip address of a hp p2055dn printer

This is usually seen on the front control panel as GW BYTE. This may be useful in identifying error conditions.ĭefault gateway (four bytes). A syslog server is a server on the network that runs a syslog daemon and is used to receive syslog messages. If no syslog server is on the network, each byte should be left at zero. Example: If the syslog IP address is 192.30.40.192, then IP byte 1 = 192, IP byte 2= 30, IP byte 3 = 40, and IP byte 4 = 192. This is usually seen on the front control panel as LG BYTE. Example: If the subnet mask address is 255.255.255.0, then IP byte 1 = 255, IP byte 2= 255, IP byte 3 = 255, and IP byte 4 = 0. This is usually seen on the front control panel as SM BYTE. Example: If the IP address is 192.0.0.192, then IP byte 1 = 192, IP byte 2= 0, IP byte 3 = 0, and IP byte 4 = 192. This is usually seen on the front control panel as IP BYTE. You must change this to No to use the front control panel configuration IP address (four bytes).

The default setting is Yes to use DHCP for configuration.

Uses DHCP, which automatically downloads configuration data over the network. You must change this to No to use the front control panel configuration.ĭHCP=(Yes/No). The default setting is YES to use BOOTP or DHCP for configuration. Uses BOOTP or DHCP, which automatically downloads configuration data over the network. See the specific printer models headings below for the steps on how to change these.īootP= (Yes/No). The following basic TCP/IP parameters can be configured using the front control panel of the printer. Following is an excerpt from one of said manuals: This is commonly found in the option of HP's JetDirect cards. The 'LG' setting refers to the IP address of a 'syslog server' if your network happens to have one - if not, just leave it set at zeroes.

How to change the ip address of a hp p2055dn printer